1.) Turn off the ability and take away the wire from the printer.
2.) Remove the paper cassette from the printer.
3.) While dealing with the entrance of the printer open the entrance door and take away the 2 screws. There is a small sheet steel bracket at the left aspect of the door that’s not captive and shall be launched when the screw is got rid of.
4.) Open the fitting aspect door. Close the secondary switch meeting. Remove the 3 screws at the left aspect, subsequent to the white plastic hyperlink arm and in moderation take away the hyperlink arm from the door.
5.) There is a hyperlink arm at the proper aspect with a small duvet subsequent to it. Remove the screw after which the quilt.
6.) Remove the twine harness from the information and disconnect the 2 connectors. Remove the 2 screws that cling the hyperlink arm mount in position and pull the door clear of the printer. It is far more uncomplicated to take away the decrease connector if you happen to first take away the twine harness from the information.
7.) To take away the fitting rear duvet,(nook duvet) take out the 2 screw that cling it on and unlock the tab on the most sensible of the quilt and rotate the ground of the quilt clear of the printer.
8.) To take away the left duvet you should first take away the 4 screws that cling the nook duvet by way of the formatter in position and take away it from the printer. The left duvet has 8 tabs on it that lock it in position. Using your thumb, press in at the decrease entrance of the quilt after which flex it out to unlock the tab and slide the quilt clear of the entrance to unlock this tab. After this tab is launched, slide the quilt in opposition to the rear of the printer after which rotate it clear of the printer and take away.
9.) There are two screws that cling the regulate panel in position, one at the entrance aspect and one at the proper aspect. Once got rid of, elevate the regulate panel up and rotate the highest clear of the printer and disconnect the connector on the regulate panel.
10.)There are 3 screws that cling the fitting entrance duvet in position, one at the entrance aspect and two at the proper. It shall be more uncomplicated to take away this cap if you happen to transfer the printer to the threshold of the desk so there’s room for the quilt to transport downward. There are 3 tabs that lock into the body. The use of a small flat blade screwdriver will lend a hand to pry in the back of the quilt and this system will paintings as neatly. Release the tabs, rotate the ground of the quilt clear of the printer after which pull down at the duvet. NOTE: Be cautious when taking out the quilt that you don’t dislodge the ability button from the quilt.
11.) Next take away the highest duvet by way of taking out one screw, situated at the left aspect below the lip up the quilt. Slide the quilt towards the left aspect of the printer to unlock it.
12.) To take away the rear duvet there are 8 screws that cling it in position. Remove the screws and slide the rear duvet in opposition to the fan aspect of the printer and take away it.
13.) The closing duvet left is the highest rear duvet and there are two screws that cling it in position. One is situated at the entrance proper aspect and the opposite at the left rear aspect. Once got rid of, slide the quilt to the left aspect of the printer to unlock it.